(a)
When optical scan technology is used to count the votes on a ballot, the provisions of this section shall apply.
(b)
The following standards shall be used to determine whether there is a clear indication on the ballot that the voter has made a definite choice. The examples used in this section refer to the "voting position target" as defined in Section
20981
. The same principles demonstrated in the examples below shall apply to all types of voting position targets on optical scan ballots, regardless of what form they may take (e.g., rectangle, oval, circle, square, open arrow).
(c)
A voter's choice shall be considered a valid vote if the voter:
(1)
Indicates their vote choice by consistently filling inside the entire voting position target.
(2)
Indicates their vote choice by consistently filling in less than the entire voting position target for all vote choices on the ballot and the ballot is processed in a manner consistent with the use procedures provided and approved for the voting system used in the county.
(3)
Indicates their vote choice by consistently placing a distinctive mark, such as (X) or (Y) or ([TICK]) or ([LEFT ARROW]), inside the associated voting position target for a candidate choice or ballot measure.
(4)
Indicates their vote choice by consistently placing a distinctive mark, such as (X) or (Y) or ([TICK]) or ([LEFT ARROW]), in the corresponding space directly above, below or beside the associated voting position target for a candidate or ballot measure.
(5)
Marks their vote choices by encircling the entire voting position target for a candidate or ballot measure, or the candidate's name or Yes/No option for a measure.
(6)
Indicates a voting error correction by using correction tape, strikeover, white-out or generic written note of instruction and marks another vote choice for the same contest on the ballot.
(7)
Writes in a qualified write-in candidate's name, or a reasonable facsimile of the spelling of the name, in the designated write-in spaces directly below the list of candidates for that office and marks the associated write-in voting target position.
(8)
Writes in a listed candidate's name in the designated write-in space and marks the associated write-in voting target position. In such case, the vote shall be counted as a single vote for the listed candidate.
(9)
Marks a voting target position for a listed candidate and also enters the listed candidate's name in the designated candidate write-in space. In such case, the vote shall be counted as a single vote for the listed candidate.
(10)
Writes in a qualified write-in candidate's name, or a reasonable facsimile of the spelling of the name, on the secrecy sleeve envelope or stub and indicates the contest for which the vote is being cast, in the case of voting systems where write-in spaces appear separately from the list of candidates for an office and do not provide voting position targets.
(d)
A voter's choice shall be considered an invalid vote if the voter:
(1)
Uses random markings, indentations, punctures or impressions, squiggly/dimpled or crimp marks, pinholes or pinpricks on a ballot, and there is no distinctive and consistent voting pattern to clearly indicate the voter's choice(s).
(2)
Indicates vote choice by filling in less than the entire voting position target, and the voter has not consistently marked the entire ballot in the same manner, making the voter's choice unclear.
(3)
Inconsistently places a mark above, below or beside the associated voting position target on a ballot, instead of inside the voting position target, and the voter's choice cannot be clearly determined.
(4)
Writes in the name of a person who has not qualified as a write-in candidate.
(5)
Writes in a listed candidate's name in the designated write-in space and fills in the associated voting position target for a different listed candidate in the same contest.
(6)
Writes in a candidate name that is unrecognizable/undecipherable and it cannot be determined for whom the vote is intended to be cast.
(7)
Writes in a qualified write-in candidate's name in the designated write-in space and does not fill in the associated voting position target for the write-in candidate. However, in the event of a manual recount, pursuant to Elections Code section
15342.5
if the intent of the voter can be determined, the vote shall be counted regardless of whether the voter has filled in the associated voting position target for the write-in candidate.
(8)
Uses pressure-sensitive stickers, rubber stamps, glued stamps, or any other device not provided for in the voting procedures for the approved voting system used by the county to indicate the name of the voter's choice for a write-in candidate.
(e)
If the voter leaves the voting booth without casting the ballot, the precinct official shall cause the ballot to be cast without examining the ballot.
Source
1. New section filed 9-28-2020 as an emergency; operative 9-28-2020. Emergency expiration extended 60 days (Executive Order N-40-20) plus an additional 60 days (Executive Order N-66-20) (Register 2020, No. 40). A Certificate of Compliance must be transmitted to OAL by 7-27-2021 or emergency language will be repealed by operation of law on the following day.
2. New section refiled, including amendment of NOTE, 7-12-2021 as an emergency; operative 7-28-2021 (Register 2021, No. 29). A Certificate of Compliance must be transmitted to OAL by 10-26-2021 or emergency language will be repealed by operation of law on the following day.
3. New section refiled 11-4-2021 as an emergency; operative 11-4-2021 (Register 2021, No. 45). A Certificate of Compliance must be transmitted to OAL by 2-2-2022 or emergency language will be repealed by operation of law on the following day.
4. Certificate of Compliance as to 11-4-2021 order, including amendment of subsection (c)(10), transmitted to OAL 1-31-2022 and filed 3-15-2022; amendments effective 3-15-2022 pursuant to Government Code section
11343.4
(b)(3)
(Register 2022, No. 11).
History
1. New section filed 9-28-2020 as an emergency; operative
9/28/2020
. Emergency expiration extended 60 days (Executive Order N-40-20) plus an additional 60 days (Executive Order N-66-20) (
Register 2020, No. 40
). A Certificate of Compliance must be transmitted to OAL by 7-27-2021 or emergency language will be repealed by operation of law on the following day.
2. New section refiled, including amendment of Note, 7-12-2021 as an emergency; operative 7-28-2021 (Register 2021, No. 29). A Certificate of Compliance must be transmitted to OAL by 10-26-2021 or emergency language will be repealed by operation of law on the following day.
3. Repealed by operation of Government Code section
11346.1
(g)
(Register 2021, No. 45).
4. Certificate of Compliance as to 11-4-2021 order, including amendment of subsection (c)(10), transmitted to OAL 1-31-2022 and filed 3-15-2022; amendments effective
3/15/2022
pursuant to Government Code section
11343.4
(b)(3)
(
Register 2022, No. 11
).